One of the first things I knew I would need to do is open up the rear fenders. I had a set of stock TJ flares that I thought would be a good starting point. 
If they aren't wide enough, there are plenty of ready made options available. I made a template of the size of opening, marked it on the Jeepster, and cut it out. At the same time, I trimmed the lower portion of the rear overhang. I wanted the flares to be level with the bottom of the flares... yes, the rockers will be history.
When I cut off the lower portion of the rear overhang, I did things a little different that with the wheel openings. I marked off the line I wanted at the bottom, and then trimmed it leaving about 1/4" below the line. Then, I folded the lower area under the panel. This gives a more finished look, as well as strengthening the panel.
| < Prev |
|---|
